M&S ABS Grille for Hyundai Genesis Sedan BH

This grille is a two piece design, the trim bezel and then the honeycomb grille face. The face is attached to the frame bezel by flexible metal tabs that bend around various parts of the edge of the honeycomb grille face. For the price I was expecting a one piece molded aftermarket grille. I used an epoxy weld at each of the metal tabs to secure it to the grille face as if you pushed on the grille from the outside once installed I could see the grille face pulling free from the metal tabs. The attachment points that secure the grille to the car are lacking as well. The top mounts are the same as the OEM grille which was nice. The bottom tabs however are just plastic nubs for lack of a better description. The OEM grill has actual plastic tabs with a raised notch that snaps into the slots on the bumper, the M&S grille does not requiring you to use some form of automotive adhesive or double sided tape to secure the bottom of the grille. Install is pretty easy but may require some trimming of the grille face in order to fit...mine did at least. All in all I am happy with the look and it's what I was after, but again, I think M&S is a bit too proud of their product in terms of price. M&S took about three weeks to ship the order, this is no fault of BTR as Sam from BTR was very helpful in contacting M&S to find out what was going on with my order. It shipped the following day and arrived three days later.